If you are looking for something special in your filament portfolio then consider ColorFabb bambooFill filament. About 80% ColorFabb PLA and 20% recycled bamboo fibers. Your prints will look absolutely amazing, and your 3D printer cave will smell like a woodshop!
Material: ColorFabb bambooFill - PLA/PHA + fine bamboo fibers One spool contains 600 grams of filament
Advised Heated Bed Temperature: (if you have one) 50 to 60 C
TIP! For stronger prints and better reliability, you can increase the flow rate about 0-10%. This will cause the filament to keep going through the hot zone at a steady pace.
Note: 3D printers have many types of hot-ends which makes it extremely difficult to give advice. Please considered these values as a starting point for determining the proper settings for your 3D printer.